Knowledge

S355JR HEM1000 Wide Flange Beams in Heavy Structures

Apr 09, 2025 Leave a message

S355JR HEM1000 is a hot rolled wide flange H-beam section that combines the European structural steel grade S355JR with the heaviest standard HEM series profile. The HEM range is the deepest and heaviest of the three European wide flange series, HEA, HEB, and HEM, and the HEM1000 is one of the largest rolled sections available in normal production. These beams are used where very high load capacity and a compact, stable cross-section are needed.

Understanding the HEM Series Designation

In European practice the HEA, HEB, and HEM series share the same nominal depth and flange width but differ in flange thickness and mass per meter; HEM has the thickest flanges and the highest section weight. The number in the designation refers to the nominal depth in millimeters, so HEM1000 has a nominal depth of 1000 mm. The section is rolled as a single piece, which gives continuous grain flow and consistent properties through the profile.

Properties of S355JR Steel

S355JR is defined in EN 10025-2, the European standard for hot rolled structural steel products. The designation indicates a minimum yield strength of 355 MPa for thickness up to 16 mm, with the yield value stepping down for thicker flanges. The letter J means the steel must meet specified impact requirements, and the letter R indicates a minimum Charpy value of 27 J at 20 deg C. The grade offers a good balance of strength, weldability, and formability, which is why it dominates general structural steelwork in Europe and many other regions.

Use in Bridge Engineering

In bridges, HEM1000 members are used as main girders, cross girders, and pier caps. The large section provides the bending stiffness needed to control deflection under self-weight, vehicle, and wind loads, while the wide flange gives stability against lateral buckling. The higher strength of S355JR allows smaller and lighter members than lower strength grades, which reduces steel tonnage and foundation loads.

Use in Large Industrial Plants

In industrial buildings, HEM1000 columns and crane girders support heavy equipment, overhead cranes, and roof structures. The massive flanges resist the high local forces from crane rails and equipment supports, and the compact section provides the stiffness required to limit sway. For tall crane columns and heavily loaded frames, the HEM series is frequently the most economical rolled alternative to built-up plate girders.

Use in High-Rise Buildings

In high-rise construction, HEM1000 sections are used as core columns, frame columns, and transfer members. They carry the gravity load of many floors and resist the horizontal forces from wind and seismic events. The deep, wide cross-section delivers high axial and bending capacity with a compact footprint, which simplifies connection design and concrete encasement in composite construction.

Frequently Asked Questions

What does HEM1000 mean? HEM identifies the heaviest European wide flange series, and 1000 is the nominal depth in millimeters, so HEM1000 is a 1000 mm deep wide flange beam.

What is the yield strength of S355JR? S355JR guarantees a minimum yield strength of 355 MPa for thickness up to 16 mm, with lower values for thicker material in accordance with EN 10025-2.

What does the JR suffix in S355JR mean? J indicates a specified impact energy requirement and R means a minimum Charpy value of 27 J at 20 deg C.

Where are HEM1000 beams typically used? They are used as bridge girders, heavy columns and crane girders in industrial plants, and core or frame columns in high-rise buildings.

Can HEM1000 beams be welded? Yes, S355JR is weldable by standard processes; for heavy sections, preheat and low-hydrogen consumables are recommended.

Is HEM1000 a standard hot rolled section? Yes, HEM profiles are standard European rolled sections produced by major structural steel mills to the dimensional tolerances of EN 10034.

Send Inquiry