Knowledge

Q245R Pressure Vessel Steel Plate

Mar 20, 2024 Leave a message

What Q245R Steel Plate Is

Q245R is a carbon steel plate grade for boilers and pressure vessels, delivered under the GB/T 713 series, which covers steel plates for pressure equipment. The designation follows the Chinese convention: Q indicates yield strength, 245 is the minimum yield value in MPa, and R stands for pressure vessel use. The grade is normally supplied in the as-rolled or normalized condition, and the plate is used for shells, heads and tube sheets of vessels that operate at moderate temperature and pressure.

The international counterpart usually quoted in tenders is ASTM A516 Grade 70, which has a minimum yield strength of 260 MPa and a tensile range of 485-620 MPa. Designers working to ASME BPVC Section VIII or to GB/T 150 commonly treat the two grades as interchangeable after stress values are verified.

Chemical Composition and Mechanical Properties

Item Requirement
Standard GB/T 713 series
Carbon (C) max. 0.20%
Silicon (Si) max. 0.35%
Manganese (Mn) 0.50-1.00%
Phosphorus (P) max. 0.025%
Sulphur (S) max. 0.015%
Yield strength, 6-16 mm min. 245 MPa
Tensile strength 400-520 MPa
Impact test Charpy V-notch, 20 degrees C

The low sulphur limit is the main difference from ordinary structural plate and is the reason Q245R resists lamellar tearing during welding of thick sections. Phosphorus and sulphur are both restricted because they control ductility in the through-thickness direction and the risk of reheat cracking during post-weld heat treatment.

Pressure Vessel Applications

Typical service includes steam drums, air receivers, LPG storage spheres, heat exchanger shells and column bodies in petrochemical plants. Because vessels are welded fabrications, the plate is ordered to a guaranteed impact energy at the specified test temperature, and weld procedures are qualified against the same toughness requirement.

Thickness range commonly supplied runs from 6 mm to about 150 mm. Plates thicker than 60 mm are generally ordered normalized to homogenize the microstructure, while plates for sour service may require additional hardness control and ultrasonic examination of the full plate area.

Inspection and Testing Requirements

Non-destructive testing of pressure vessel plate is performed to NB/T 47013, which defines ultrasonic testing methods and acceptance levels for the plate and the finished welds. Common acceptance tests are ultrasonic examination of the plate body, edge preparation checks and a hydrostatic or pneumatic proof test on the completed vessel.

For procurement, the purchase order should state the standard number, the delivery condition, the impact test temperature and the acceptance level for ultrasonic testing. A plate that satisfies the chemistry but is unexamined volumetrically can fail during vessel fabrication and should not be accepted on a certificate of analysis alone.

Frequently Asked Questions

Q: What does the R in Q245R mean?
A: R identifies pressure vessel use; the full designation means a steel with a minimum yield strength of 245 MPa intended for boilers and pressure vessels.

Q: Which standard covers Q245R plate?
A: The GB/T 713 series for steel plates for pressure equipment. The older designation GB 713 refers to the same material family, and the current edition should be confirmed on the order.

Q: What is the minimum yield strength of Q245R?
A: 245 MPa for plate thickness from 6 mm to 16 mm, with the tensile range specified as 400-520 MPa.

Q: Which grade replaces Q245R in ASME design?
A: ASTM A516 Grade 70 is the usual equivalent, with a minimum yield strength of 260 MPa and a tensile range of 485-620 MPa.

Q: How is Q245R plate inspected for internal defects?
A: By ultrasonic testing to NB/T 47013 at the acceptance level agreed in the purchase order, in addition to the mill chemical and mechanical tests.

Send Inquiry