The Q235 H-beam is a structural steel component made from Q235 grade carbon steel, with an H-shaped cross-section. It is produced by hot rolling as a single piece, in which the web and the two flanges are rolled together rather than assembled. Q235 is the Chinese carbon structural steel specified in GB/T 700, and the H-beam made from it is commonly used in construction and engineering for structural support because of its strength, stability, and ease of fabrication.
Material Composition
The Q235 steel used for H-beams has a typical composition with carbon limited to 0.22 percent, manganese of 0.30 to 0.60 percent, silicon of 0.15 to 0.30 percent, and phosphorus and sulfur each limited to 0.045 percent. The low carbon content keeps the steel weldable and formable, while manganese provides moderate strengthening. The steel is supplied in the grades Q235A, Q235B, Q235C, and Q235D, which differ in their chemical limits and toughness requirements.
Mechanical Properties
Q235 has a minimum yield strength of 235 MPa, which is the stress required to cause permanent deformation, and a tensile strength of 375 to 500 MPa. Minimum elongation is about 20 to 25 percent, which indicates good ductility, and the modulus of elasticity is about 210 GPa, typical for carbon steels. The Brinell hardness is typically 120 to 180 HB, which is relatively soft compared with higher-strength grades such as Q345, and this makes the steel easy to machine, drill, and weld.
Geometry and Common Sizes
The cross-section of an H-beam consists of a vertical web, the central part, and two horizontal flanges at the top and bottom, which together resemble the capital letter H. The main dimensions are the height, the flange width, the web thickness, and the flange thickness. Common sizes of Q235 H-beams include 100 by 100 by 6 by 9 mm, 200 by 100 by 8 by 12 mm, 300 by 150 by 10 by 15 mm, 400 by 200 by 12 by 20 mm, and 500 by 250 by 15 by 25 mm, with the values indicating height, flange width, web thickness, and flange thickness respectively.
Advantages of Q235 H-Beams
Q235 H-beams combine the structural efficiency of the H-section with the economy of a plain carbon steel. The wide flanges give high bending resistance and stable behavior under compression, and the section is easy to connect with bolted or welded joints. Because Q235 is low in cost and easy to fabricate, H-beams made from it are a practical choice for general structural frames where the design strength is within the capacity of the grade.
Typical Applications
Columns, beams, and trusses in building frames and bridges
Structural support in industrial facilities and workshops
Equipment bases and machine supports
Mezzanine floors and platforms
General steel structures where moderate strength and economy are required
Frequently Asked Questions
What is a Q235 H-beam? It is a structural steel member made from Q235 carbon steel with an H-shaped cross-section, used for structural support in construction.
What is the yield strength of Q235? The minimum yield strength is 235 MPa and the tensile strength is 375 to 500 MPa.
What are the common sizes of Q235 H-beams? Common sizes range from 100 by 100 by 6 by 9 mm up to 500 by 250 by 15 by 25 mm and larger.
Is the Q235 H-beam welded or assembled? Standard H-beams are hot rolled as a single piece, with the web and flanges rolled together.
Is Q235 H-beam weldable? Yes, the low carbon content gives it good weldability with standard processes.
What standard covers Q235 steel? Q235 is specified in GB/T 700, the Chinese standard for carbon structural steels.

