Knowledge

Characteristics and process flow of flat steel

Dec 21, 2023 Leave a message

Characteristics and process flow of flat steel


1. Special product specifications. The thickness is 8 ~ 50mm, the width is 150-625mm, the length is 5-15m, and the product specification file distance is dense, which can meet the needs of users, and can be used instead of the middle plate, without cutting, and can be directly welded.


2. Smooth surface of the product. High-pressure water descaling process is used twice in the process to ensure smooth steel surface.


3. The two sides are vertical and the water corners are clear. Two vertical rolling in finishing rolling ensures good verticality, clear Angle and good surface quality of both sides.


4. The scale of the product is accurate, the three-point difference, the level difference is better than the steel plate standard; The product is flat and straight, and the plate shape is good. Finishing rolling adopts continuous rolling process, automatic loop automatic control, to ensure that no stacking steel does not pull steel, product dimensional accuracy is high, tolerance range, three point difference, the same strip difference, sickle bend and other parameters are better than the plate, and the plate straightness is good. Cold cutting, high precision length measurement.


5. The product material adopts the national standard, the same as the steel plate. Quality and technical standards according to YB/T4212-2010 standard organization of production (Q345B/Q235B refer to GB/T1591-94, GB/T700-06 standards, respectively).

flat bar

Process flow
The working principle of the flat steel finishing machine is to pre-calibrate and finally level the thickness direction of the cold flat steel wool with two sets of leveling wheels staggered up and down. The width direction is squeezed by a pair of finishing wheels arranged relative to each other, so that the width is compressed to reach the expected parameter, and the compression amount is adjustable. 5 staggered straightening wheels are used to straighten the width. The system is mainly composed of control box, finishing roller, pre-leveling unit, finishing unit and straightening unit.


The production process can be summarized as: pre-levelling → finishing → straightening → post-levelling. Flat steel /a/b 12-300mm wide, 4-60mm thick, rectangular section and slightly with pure edge steel. Flat steel can be finished steel, or it can be used as blank for welding pipes and thin slab for rolling sheet. Main uses: Flat steel as a material can be used to make hoop iron, tools and mechanical parts, and used as building frame structural parts and escalators. Flat steel is divided into two types according to its shape: flat spring steel and single-sided double-groove spring flat steel. Hot-rolled spring flat steel is mainly used to manufacture leaf springs on automobiles, tractors, railway transportation and other machinery.

 

If you have more needs and questions about steel, please contact us!

flat-rolled steel

 

GNEE Group receives visiting customers

 

ribbon iron

 

GNEE office environment

Send Inquiry