Galvanized Angle steel process flow
Hot-dip galvanized Angle steel process: Angle pickling → water washing → dip plating solvent → drying and preheating → hanging plating → cooling → passivation → cleaning → polishing → hot-dip galvanized finish. The galvanized layer of hot-dip galvanized Angle steel is uniform in thickness, up to 30-50um, and has good reliability. The galvanized layer is combined with the steel and becomes a part of the steel surface, so the coating durability of hot-dip galvanized Angle steel is more reliable.
1. Hot-dip galvanized Angle steel is also called hot-dip galvanized Angle steel or hot-dip zinc Angle steel. It is to immerse the Angle steel after rust removal into the melting zinc liquid about 500℃, so that the surface of the Angle steel is attached to the zinc layer, so as to play the purpose of anti-corrosion, suitable for a variety of strong acid, alkali fog and other strong corrosion environment.
Angle steel pickling - water washing - dip plating solvent - drying preheating - hanging plating - cooling - passivation - cleaning - polishing - hot dip galvanizing completed. The galvanized layer of hot-dip galvanized Angle steel is uniform in thickness, up to 30-50um, and has good reliability. The galvanized layer is combined with the steel and becomes a part of the steel surface, so the coating durability of hot-dip galvanized Angle steel is more reliable. The raw material of hot-dip galvanized Angle steel is Angle steel, so it is classified as Angle steel.

2. Cold galvanizing process is used to protect the metal from corrosion, for this purpose, the use of zinc filler coating, in the use of any kind of coating method is coated on the protected surface, after drying to form a zinc filler coating, in the dry coating has a content of zinc (up to 95%). Suitable for repair work (that is, in the course of repair work, only in the place where the protected steel surface is damaged, as long as the surface is repaired, it can be recoated). Cold galvanizing process is used for corrosion protection of various steel products and structures.
Cold galvanized coating is mainly anti-corrosion through the electrochemical principle, so it is necessary to ensure that the zinc powder is in full contact with the steel, resulting in electrode potential difference, so the surface treatment of steel is very important. Before spraying cold galvanizing, mechanical rust removal (sandblasting, shot blasting, etc.) should be selected to make the surface cleanliness of the steel reach ISO 85O1-1 Sa 2.5, equivalent to GB 8923 Sa 2.5. Its text is defined as: "After mechanical rust removal, the surface of the steel is free of oil, rust, no oxide and other dirt, or only leave slight traces; 95% of the steel surface is hit by steel pellets (sand), exposing the luster of the metal."
For roughness, another indicator of surface treatment quality, different cold galvanized materials have different requirements for roughness. In the construction description of Zinga, the average roughness Ra=12.5, that is, the roughness Rz=55 ~ 75 microns. In the "strong zinc" and "Robaru" construction instructions, the requirements for roughness are slightly lower, Rz=40~60 microns.
If the cold galvanized film is formed separately, as an anti-corrosion coating, the surface roughness can be controlled slightly smaller to ensure the coating thickness of cold galvanized; When cold galvanizing is used as the bottom layer of heavy anti-corrosion coating, and the total supporting coating thickness is greater than 180 microns, in order to ensure the adhesion of the entire coating, the steel surface roughness Rz should be greater than 60 microns.
If you have more needs and questions about steel, please contact us!

GNEE Group receives visiting customers

GNEE office environment

